|CAS #: 9002-88-4|
|ACUTE HAZARDS||PREVENTION||FIRE FIGHTING|
|FIRE & EXPLOSION||Combustible. Gives off irritating or toxic fumes (or gases) in a fire. Finely dispersed particles form explosive mixtures in air.||NO open flames. Closed system, dust explosion-proof electrical equipment and lighting. Prevent deposition of dust.||Use water spray, powder, foam, carbon dioxide.|
|Inhalation||Cough.||Avoid inhalation of dust.||Fresh air, rest.|
|Skin||Remove contaminated clothes. Rinse and then wash skin with water and soap.|
|Eyes||Wear safety goggles.||First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.|
|Ingestion||Do not eat, drink, or smoke during work.|
|SPILLAGE DISPOSAL||CLASSIFICATION & LABELLING|
|Sweep spilled substance into covered suitable, labelled containers. If appropriate, moisten first to prevent dusting. Personal protection: particulate filter respirator adapted to the airborne concentration of the substance.||
According to UN GHS Criteria
|Separated from incompatible materials. See Chemical Dangers.|
|PHYSICAL & CHEMICAL INFORMATION|
Physical State; Appearance
|EXPOSURE & HEALTH EFFECTS|
Routes of exposure
Effects of short-term exposure
Effects of long-term or repeated exposure
|OCCUPATIONAL EXPOSURE LIMITS|
|LDPE means Polyethylene with low density; HDPE means Polyethylene with high density.
Physicochemical properties vary depending upon the molecular mass.
Thermal degradation starts at 290°C.
The PE products are available in large selection of various forms, due to additives used in the manufacture.
The additives can influence the physical and toxicological properties of this substance.
|All rights reserved. The published material is being distributed without warranty of any kind, either expressed or implied. Neither ILO nor WHO nor the European Commission shall be responsible for the interpretation and use of the information contained in this material.|